Descargar Imprimir esta página

Jensen RealFlame 1590LP-CBN Manual Del Propietário página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Igniter
1. Read and understand all operating instructions before lighting.
2. Before beginning, make sure the control knob is in the "OFF" position.
3. Connect your LP gas tank (see previous pages).
4. Slowly open the valve on your LP gas tank.
5. Prepare to ignite your fireplace by placing one hand on the control
knob and one hand on the igniter button (see diagram). DO NOT
lean over any part of the burner. Verify that the area around the
burner is free of hazards.
6. Push and hold the igniter button. You should hear a clicking sound.
7. While keeping the ignition button depressed, use your other hand to push in and turn the
control knob counterclockwise to the "LIGHT" position.
8. Once the burner ignites, release the igniter button, but continue to keep the control knob
pushed in for 15 seconds.
WARNING: If ignition does not occur in 15 seconds, turn the control knob to the "OFF"
position and turn the gas o
the fireplace and wait at least 5 minutes until the gas has cleared to repeat the lighting
procedure. Failure to do so could result in a large flashback of pooled gas, causing property
damage, serious injury, or death.
9. After successfully lighting the fireplace, release the control knob and turn it to the "LOW" setting.
Observe the flame and make sure that all the burner ports are lit.
10. Adjust the flame to the desired height using the control knob.
Control Knob
Shut-O
Instructions
1. Turn the control knob to the "OFF" position.
2. Close the valve on the LP gas tank to shut o gas flow.
LIGHTING INSTRUCTIONS
at its source. Make sure there is no source of ignition around
Flame Height
10
8-14"
(20.3-35.5 cm)

Publicidad

loading

Este manual también es adecuado para:

Realflame 1590lp