Schlage MTB15 Manual De Instrucciones página 2

4
Install baseplate with bottom screw.
In case of alternative mounting screws, only a #6 diameter Pan Head
Screw should be used.
L Baseplate must always be used when mounting the unit.
5
Plug cable into reader.
6
Install reader with upper screw.
In case of alternative mounting screws, only a #6 diameter Pan Head
Screw should be used.
L Lower mounting screw not required when using back
plate, unless not using the anti-tamper feature.
7
Snap cover into place and install cover screw.
Tamper Resistant
6-32 x Z\v"
Pin-in-Torx
button
head, Use if
desired.
Regular
6-32 x Z\v"
Do not
over-tighten!