Instructions for Use
90°
Fig. 18
Cooling
When set to position
cools and dehumidifies the air in the
room at the same time in order to create
a pleasant atmosphere.
• Plug the appliance into the mains
electricity supply.
• Lead the hot air expulsion tube outside.
In order to avoid excessive noise and
efficiency loss, the air expulsion tube
should be positioned as shown in,
Fig. 13. See "Temporary installation".
• Check that the plug, Fig. 1, is fitted on
the drainage pipe to prevent water from
leaking onto the support surface.
• Lift the air director on the top of the
appliance. This air director is not
installed on the appliance on 3XM4.1E
models. See figures 26 and 27 i n
"H e a t i n g".
• Select the silent
, high
cooling function, Fig. 19.
Fig. 19
All manuals and user guides at all-guides.com
0°
, the appliance
or turbo
44
• Set the thermostat to the desired
temperature, Fig. 9. If the appliance
turns itself off automatically because
the temperature set for the room has
been reached and it is necessary to
wait for ambient temperature to rise 2-
3°C before it comes back on again.
Fig. 20
During air conditioning, some of the
condensed water produced evaporates
automatically and is expelled outdoors
together with the expelled air through the
hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water
in an internal tank. When a certain level
is reached an indicator light, Fig. 3,
comes on indicating that the condensed
water tank is full and needs to be
emptied. When this happens, the
appliance stops cooling the air in the
room until the water is drained, as
explained in "Transportation
requirements", Fig. 7.
• It is recommended that you turn the
appliance off while draining the water.
Warning!
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before turning
it back on again. This period of time is
required in order to ensure correct
appliance operation.
Dehumidification
In this operation function, the appliance
reduces the humidity in the atmosphere
and purifies the air.
• Set the thermostat to its minimum
temperature setting, Fig. 21.