Publicidad
Idiomas disponibles
Idiomas disponibles
Atlantic's FB3200/FB4600 Fountain Basins have a
recessed pocket that allows 1½" conduit sleeves
to be installed within the circumference of the
basin without notching for the pump cord
and low voltage wiring. A 1½" cord stopper is
included to plug the top of the sleeve to prevent
gravel and other debris from entering the conduit.
FBKIT3 INSTALLATION INSTRUCTIONS
Step 1:
Install the pump. The above diagram shows the proper installation of the discharge fittings
and Triton 3-Way Diverter when used with the FB4600 Fountain Basin and TidalWave pumps.
Discharge fittings are included for the connection of the MD1000-1500, TT1500-3000. If
installing the MD1000/1250/1500 the 1" x 1½" adapter fitting included with the pump must be
used to accept the 1½" male thread adapter. If installing a TT1500/2000/3000, the threaded
coupling that is supplied with the pump must be used to accept the 1½" male
thread adapter.
*NOTE:
This plumbing kit is intended for use with the FB4600 fountain basin. This plumbing kit can be
installed with the FB3200 fountain basin, however, the Atlantic Triton 3-Way Diverter must be
installed inside the pump chamber and accessed by removing the pump cover. The FB3200
is supplied with one predrilled hole that will accept a feed line up to 1" in diameter. Additional
holes will need to be drilled on site to install this plumbing kit. Drill points have been provided
on either side of the factory opening to show the proper location for additional feed lines.
Triton 3-WAY 11/2" MTA
11/ 2 " STREET 90
& 11/ 2 " MALE ADAPTER
MD1000 - MD1500
(NOT INCLUDED)
2" Fernco
11/2" 45
11/2" PVC
11/ 2 " STREET 90
& 11/ 2 " MALE ADAPTER
TT1500 - TT3000
(NOT INCLUDED)
3
Publicidad
