Tabla de contenido
Publicidad
OPERATION INSTRUCTIONS
SWITCHING ON / SWITCHING OFF
The mains voltage must match the voltage on
the label of the screwdriver.
Switching on: press the switch button and hold
in this position.
Switching off: release pressure on the switch.
LOCKING THE SWITCH
(CONTINUOUS OPERATION)
Switching on:
• Press the switch button
and hold in this position.
• Press the switch lock but-
ton.
• Release pressure on the switch button.
Switching off:
• Press and release the switch.
Rotational speed of the spindle is controlled
with pressure on the switch button. Screw-
driver transmits drive to the working bit only
after it is pressed against processed material or
a screw head.
LEFT & RIGHT DIRECTION OF ROTATION
Choose direction of the screwdriver spindle
rotation with the direction selector switch.
Right rotation: move the switch to the extreme
right position.
Left rotation: move the switch to the extreme
left position.
* The possibility is reserved that in certain cases
position of the switch relating to rotation di-
rection may be different than specified. Please
refer to graphic signs placed on the switch or
tool body.
IMPORTANT: Do not change direction of
rotation when the spindle of the screwdriver
is rotating. Ensure the position of the selector
switch is correct before starting the tool.
SCREWING DEPTH CONTROL
With control ring you can set up the depth of
the screw head sinking into material. Set re-
quired screwing depth by turning the control
ring.
Turning clockwise: Increases the screwing
depth
Turning
counter-clockwise:
screwing depth .
It is best to set correct screwing depth by test
screwing in waste material. Screw is held by
universal magnetic holder. Press the screw tip
against material it is to be screwed into until
the depth limiter reaches the material, and the
screwing tip disconnects. To unscrew screws set
the switch lever to the extreme left position.
SCREWDRIVER BODY HOOK
Screwdriver body hook is very useful when
working , during breaks it allows to hang the
screwdriver e.g. on a tool belt.
Unplug the power cord from the mains socket
before commencing any activities related to in-
stallation, adjustment, repair or maintenance.
Screwdriver does not require any addition al
lubrication or special maintenance. There are
no user serviceable parts inside the tool.
Never use water or other chemical liquids for
cleaning the screwdriver. Wipe the tool with a
dry cloth.
Always keep the screwdriver in a dry place.
Always keep the ventilation holes on the
screwdriver body pervious.
In case of power cord damage replace it with
a cord with the same specification. Entrust
the repair to a qualified specialist or take the
screwdriver to a service shop.
CARBON BRUSH REPLACEMENT
Replace immediately worn out (shorter than 5
mm), burnt or cracked motor carbon brushes
with the new ones. Always replace both brush-
es at a time.
Entrust replacement of carbon brushes only to
a qualified person. Only original parts should
be used.
VOLTAGE-FREQUENCY
SPEED
BIT HOLDER CAPACITY
POWER
WEIGHT
Decreases
the
E N G L I S H •
MAINTENANCE
TECHNICAL DATA
U se r' s m a nu a l
120 V ~ 60 Hz
(0 - 4 500) r/min
1/4" (6,3 mm)
520 W
1,43 kg (3,1 lb)
9
Publicidad
Tabla de contenido
