Descargar Imprimir esta página

Pfister KENZO 40 Serie Instrucciones De Montaje página 2

Ocultar thumbs Ver también para KENZO 40 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide
long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illus-
trated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty
• PTFE Plumber's Tape
• Adjustable wrench
• Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
B
C
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Faucet
D Metal Washer
B Base Plate
E Long Nut
C Putty Plate
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
• Slotted screwdriver
• Flashlight
A
D
E
ENGLISH
FAUCET INSTALLATION
5
5 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in bottom of Putty Plate (5A). Ensure that Putty Plate (5A) is pressed on Base
Plate (5B). Assemble Base Plate (5B) and Putty Plate (5A) to Faucet Body (5C). With
the handle and spout facing forward, carefully insert Threaded Shank (5D) and Faucet
Inlets (5E) through hole on sink.
6
6B
6 SECURING FAUCET
From underneath sink, secure Faucet Body (6A) by placing Metal Washer (6B) and
7
threading Long Nut (
/
16
bumps on Metal Washer (6B) are facing up. Firmly hand tighten Long Nut (6C). Secure
Long Nut (6C) not to exceed a quarter turn.
Caution: Do not over tighten!
2
5B
6A
6D
6C
" Hex.) (6C) onto Threaded Shank (6D). Make sure that the
5C
5D
5A
5E

Publicidad

loading