Publicidad
Idiomas disponibles
Idiomas disponibles
4
Preparation
4.1 Things to be done for
energy saving
Connecting the product to electric energy
A
saving systems is risky as it may cause
damage on the product.
• Do not leave the doors of your refrigerator open
for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload the refrigerator. Cooling
capacity will fall when the air circulation inside
is hindered.
• Do not place the refrigerator in places subject
to direct sunlight. Install the product at least 30
cm (12in.) away from heat sources.
• Pay attention to store your food in refrigerator
in closed containers.
• You can load maximum amount of food to the
freezer compartment of the refrigerator by
removing the freezer compartment shelf of
drawer. Declared energy consumption value
of the refrigerator was determined with the
freezer compartment shelf or drawer removed
and with maximum amount of food loaded.
There is no risk in using a shelf or drawer
suitable for the shapes and sizes of the foods
to be frozen.
• Thawing frozen food in refrigerator
compartment will both provide energy saving
and preserve the food quality.
The ambient temperature of the room
C
where you install the refrigerator should
10ºC /50°F
at least be
refrigerator under cooler conditions than
this is not recommended.
C
Inside of your refrigerator must be cleaned
thoroughly.
If two refrigerators are to be installed side
C
by side, there should be at least 4 cm
(1.6in.)
distance between them.
4.2 Recommendations for the
• Do not allow the food to touch the temperature
• Do not put hot food and beverages inside the
. Operating your
14 /28 EN
fresh food compartment
sensor in fresh food compartment. To allow the
fresh food compartment keep its ideal storage
temperature, sensor must not be hindered by
food.
product.
Refrigerator / User Manual
Publicidad
