Publicidad
Idiomas disponibles
Idiomas disponibles
3 USING THE APPLIANCE
3.1 Information on Less Frost
Technology
Thanks to the wrap around evaporator,
Less Frost technology offers more efficient
cooling, less manual defrost requirement,
and more flexible storage room.
3.2 Thermostat Setting
The thermostat automatically regulates
the temperature inside the refrigerator and
freezer compartments. Cooler temperatures
can be obtained by rotating the knob to
higher numbers, 1 to 5.
Important note: Do not try to rotate
the knob beyond position 1, it will stop
your appliance from working.
Super switch
(In some models)
Lamp cover
Thermostat Settings
• Set the knob to a low/medium position,
up to 3, for short-term storage of food in
the appliance.
• Set the knob to a medium position, 3 or
4, for long-term storage of food in the
appliance.
• Set the knob to 5 position for freezing
the fresh food. The appliance will run for
colder temperatures.
Super freezing: This switch shall be used
as superfreeze switch. For maximum
freezing capacity, please turn on this switch
before 24 hours placing fresh food. After
placing fresh food in the freezer, 24 hours
ON position is generally sufficient. In order
to save energy, please turn off this switch
after 24 hours from placingfresh food.
Winter Switch: If ambiant temperature
is below 16
C, this switch shall be used
o
as winter switch and it keeps your fridge
Thermostat knob
EN - 61
above 0
C while freezer is below -18
o
low ambiants.
3.3 Temperature Settings Warnings
• The ambient temperature, temperature of
the freshly stored food and how often the
door is opened affects the temperature in
the refrigerator compartment. If required,
change the temperature setting.
• It is not recommended that you operate
your fridge in environments colder than
10°C in terms of its efficiency.
• When setting the thermostat, take into
consideration how often the appliance
doors are opened and closed, how much
food is stored in the refrigerator, and the
environment in which the refrigerator is
located.
• When the appliance is first switched on,
allow it to run for 24 hours in order to
reach operating temperature. During this
time, do not open the door and do not
keep a large quantity of food inside.
• Unplug your appliance during a power cut
to prevent damage to the compressor.
Once power is restored, delay plugging
in your appliance for 5 to 10 minutes.
This will help prevent damage to the
appliance's components.
• Your appliance is designed to operate in
the ambient temperature ranges stated
in the standards, according to the climate
class stated in the information label. It
is not recommended that your fridge is
operated in the environments which are
outside of the stated temperature ranges.
This will reduce the cooling efficiency of
the appliance.
• Your appliance is designed to operate in
the ambient temperature (ST/SN = 10°C
- 38°C) intervals stated in the standards,
according to the climate class displayed
on the information label. We do not
recommend operating your appliance out
of the stated temperature limits in terms
of cooling effectiveness.
C in
o
Publicidad
