Numatic HVR 200M-11 Instrucciones Originales página 9

Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all electrical
equipment, care and attention must be exercised at all times during use, you must also make certain
that routine and preventative maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct
WARNING
standard could render this equipment unsafe and the manufacturer can accept no responsibility in
this respect.
This machine is for DRY USE only
You must disconnect the machine from the mains by removing the plug from the supply socket BEFORE cleaning or
maintenance and when replacing parts or converting the machine to another function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dusts. Contact your
local distributor if you require a machine capable of performing these tasks.
This machine is not a toy; children shall not play with this machine.
The machine must not to be used by persons with reduced physical, sensory or mental capabilities, or lack of
experience or knowledge, unless they have been given supervision or instruction.
You must not allow the supply cord to come into contact with rotating brushes (if fitted).
Only use the socket outlet on the machine for purposes specified in the instructions (where fitted).
This machine must not be stored outside, or used in wet environments, or to collect wet materials.
The vacuum cleaner should be stored in a dry place and is for indoor use only.
You must ensure that the filtration system fitted to the machine is suitable for the material being
collected.
CAUTION
This product complies with the requirements of EN 60335-2-69 2012.
NOTES
The primary use for this machine is commercial, for example in hotels, schools,
hospitals, factories, shops and offices.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and inspect the floor tool,
wands and hose for debris. If the floor tool, wands and hose are clear, replace the dust bag and clean the filter.
The vacuum cleaner should be inspected after use for damage.
The power light will illuminate, when your machine is connected to a suitable power supply (where fitted).
● Keep your machine clean.
● Keep filters clean.
● Use filter bags, they will enhance performance and help keep machine clean.
● Use a Numatic original filter bag under fine dust conditions.
● Keep hoses and tubes clear.
DO
● Replace any worn or damaged parts immediately.
● Regularly examine the power cord. If damage is found such as cracking or ageing the power cord
must be replaced by a competent person using the correct Numatic original part.
● Change dust bag frequently.
● Keep diffuser filter (where fitted) clean.
● Only use the brushes provided with the machine. The use of other brushes may impair safety.
● Unreel the cable with one pull or pull on the cable to unplug the machine from the power supply.
● Use to suck up hot ashes or lighted cigarette ends.
● Use steam cleaners, pressure washers or immerse in water to clean the machine.
● Attempt machine maintenance or cleaning unless the power supply plug has been removed from
the supply outlet.
DON'T
● Use in a wet environment or to collect wet materials.
● Store your machine in wet conditions.
Information for dry use vacuum cleaners