Publicidad
Idiomas disponibles
Idiomas disponibles
WM-5 Manual V 1.00 — English
Getting Started
Your WM-5 package contains one 400-Hr Lithium CR2032 battery, a lanyard, and voltage input
numbers for humidity calibration. It is very important that you keep the calibration numbers
for future calibration needs. Each instrument has unique voltage input numbers. To install the
lanyard, feed one end through the hole at the bottom of the handle and tie it to the other end.
Open case and click into fully opened position or, if using a tripod, click to the 90-degree
position. Your WM-5 sensors are extremely sensitive. Hold the WM-5 at the bottom of the
handle, away from your face and body, to avoid getting false readings. It is also important
that you do not touch the sensors.
Replaceable
Impeller
Humidity
Sensor
6845 W. Frye Road
Chandler, AZ 85226 USA
Operating Modes:
Turn the unit on using the ON/OFF button on
the left. Use the MODE button on the right
to scroll to the desired function. To turn off
Temperature
the unit, press and hold the ON/OFF button
Sensor
for 3 seconds, until the display is blank, then
Pressure
release.
History
Value
Changing the Units of Measure:
Screen
With the WM-5 on, change the units of
measure by selecting the mode you wish to
change (i.e. Wind speed). Next, press and
Tripod
Mount
hold the ON/OFF button and, while holding,
press the MODE button to change the units
of measure.
(480) 346-3380
www.ambientweather.com
Publicidad
