Hilti NMX 6-22 Manual De Instrucciones Original página 10

3 Description
3.1 Product overview
3.2 Intended use
The product described is a mixer. It is designed for mixing materials of low or high viscosity, depending on
the mixing paddle used.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
•
operating instructions.
3.3 Items supplied
Mixer, mixing paddle, chuck key, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable
at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is
switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
6 English
1
Battery interface
@
Speed selector switch
;
Grips
=
Switch-on interlock
%
On/off switch
&
Chuck key
(
Spindle locking switch
)
Key chuck
+
Release button, battery
§
Battery status indicator
/
Battery
:
Mixing paddle
∙
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
2341692
*2341692*