Orbegozo HOT 710 Manual De Instrucciones página 14

HOT 710
ATTENTION: do not cover the appliance when it is
operating to avoid the risk of fires.
ATTENTION: This symbol show: Hot surface. The
temperature of the door or the outer surface may be high
when the appliance is operating.
INSTALLATION
This oven has not been designed to be built-in. Place the unit on a dry and smooth surface and make sure
that the oven is a minimum 50 cm away from the wall and 20 cm both sides. The back should be placed
against the wall. Do not place it close to a closet.
Make sure the door can be completely open without resistance.
OPERATION AND USE OF THE OVEN
Orbegozo midi-oven is designed to be more economical and secure so as to ensure a longer useful life and
it is also equipped with a thermostat, a timer and two-way switches.
Insert the oven's plug into a socket. A yellow warning light shall come on to warn you that your oven
-
is supplied with electricity and is ready to be operated.
By means of the timer button, you are enabled to ensure that your oven is operated during a pre-
-
determined period of time in compliance with table 1 and is then automatically turned off.
By means of the thermostat button, you could set your oven's temperature. This button serves to
-
ensure that your oven automatically starts and then turns off at desired temperatures. A red warning
light shall warn you when the thermostat and timer are on. The light shall go out when the timer or
thermostat is off.
The third switch will allow you to activate the upper and lower heating elements, both heating
-
elements in turn, the grill will start and the rotisserie will turn.
The switch will allow you to turn on the light and / or connect the convection.
-
14