Publicidad
Idiomas disponibles
Idiomas disponibles
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
Flat-blade screw
screwdriver (+)
Allen wrench
Pliers
(3/16") (5 mm)
With the door opened
1. Remove 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
2. Disconnect two connectors ( 2 ) on the left side
door. To remove the water coupler from the
hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
(2)
(3)
DA68-02953A-12.indb 11
Socket wrench
driver (-)
(13/32") (10 mm)
(1)
(4)
English - 11
3. Pull and remove the hinge lever ( 5 ).
Remove the ground screw ( 6 ) attached to the
upper left door hinges with a philips screwdriver
(+). Remove the upper left and right door
hinges ( 7 ).
(5)
(7)
4. Lift the door straight up to remove.
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+).
Remove the 2 hex head bolts ( 9 ) attached to
the lower left and right door hinges with an allen
wrench (3/16").
Remove the lower left and right door hinges
( 10 ).
(10)
(8)
(9)
Allen wrench
(6)
2017. 8. 8.
9:04
Publicidad
