Uline H-9468 Manual De Instalación página 3

LOCKING THE MOUNTING BRACKET
1. Using needle-nose pliers, detach the locking pin
from the mounting bracket. (See Figure 4)
Figure 4
Locking Pin
2. Insert the locking pin through the hole on the back
of the smoke/CO detector. (See Figure 5)
Figure 5
3. When attaching the smoke/CO detector to the
mounting bracket, the locking pin's head will fit into
a notch on the bracket.
PAGE 3 OF 9
INSTALLATION CONTINUED
Locking Pin
1-800-295-5510
uline.com
UNLOCKING THE MOUNTING BRACKET
1. Insert a flathead screwdriver between the mounting
bracket and the locking pin. (See Figure 6)
Figure 6
2. Pry the smoke/CO detector away from the bracket
by pushing up the screwdriver and turning the
smoke/CO detector counterclockwise at the same
time.
0721 IH-9468