MōDRN HYN-LK1DCB-GY Instrucciones De Montaje página 7

STEP-BY-STEP ASSEMBLY:
STEP 3:
Carefully tap small wooden dowels into place. Leave 1/2" of the dowels sticking
3
out. Insert H2 into panel H. Refer to page 5 on how to use the cam lock system. Ensure all
hardware pieces are properly tightened.
STEP 4:
Make sure the screws go through the pre-drilled holes. Carefully tap small wooden
4
dowels into place. Leave 1/2" of the dowels sticking out. Insert H2 into panel A. Refer to page
5 on how to use the cam lock system. Ensure all hardware pieces are properly tightened.
properly. Do not over tighten screws.
7/11