Ryobi TC4011 Manual Del Operador página 10

INSTALLING CUTTING WHEEL
See Figures 5 - 6, page 16.
 Unplug the saw.
 Hold the outer cutting wheel washer still using the hex
box wrench.
 With your other hand, use the hex "T" wrench to remove
the cutting wheel screw by turning it clockwise.
 Remove outer cutting wheel washer.
WARNING:
If inner flange bushing has been removed, replace it
before placing wheel on spindle. Failure to do so will
prevent wheel from tightening properly and could result
in serious personal injury.
DANGER:
Keep hands away from cutting area and the cutting
wheel. Keep your second hand on auxiliary handle, or
motor housing. If both hands are holding the saw, they
cannot be cut by the cutting wheel.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shield marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ASSEMBLY
 Check to see that the arrow on the wheel and the arrow
on the saw are pointing in the same direction.
 Fit the cutting wheel inside the wheel guard between the
two nozzles of the water supply and onto the inner flange
bushing.
 Replace the outer cutting wheel washer.
 Hold the outer cutting wheel washer still using the hex
box wrench.
 Align the outer cutting wheel washer with the inner cutting
wheel bushing until it engages.
 Tighten cutting wheel screw securely by turning it coun-
terclockwise with the hex "T" wrench.
NOTE: Never use a wheel that is too thick to allow the
outer cutting wheel washer to engage with the flat on the
spindle.
OPERATION
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, cutting wheel
washers, hoses, fittings, etc. Tighten securely all screws,
washers and fittings and do not operate this product until
all missing or damaged parts are replaced. Please call
1-800-525-2579 or contact an authorized service center
for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 Wet or dry cross cutting, rip cutting, and bevel cutting of
man-made tile, pavers, and natural stone tile products
CUTTING WHEELS
The best of cutting wheels will not cut efficiently if they are
dull or badly worn. Using a dull wheel will place a heavy
load on the saw. Keep extra wheels on hand, so that sharp
wheels are always available.
WARNING:
Since wheel is exposed on underside of work, keep
hands and fingers away from cutting area. Any part of
your body coming in contact with moving wheel may
result in serious injury.
STARTING/STOPPING THE SAW
See Figure 7, page 16.
To start the saw: Depress the switch trigger.
Always let the wheel reach full speed, then guide the saw
into the workpiece.
10 — English