Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHT FIXTURE INSTALLATION
For best performance, mount the fixture about 6 feet (1.8 m)
above the ground.
1. Remove two decorative nuts.
2. Remove mounting plate.
3. Tighten mounting screws finger tight.
4. Set sensitivity control on back of fixture to MIN
position.
5. Attach mounting plate to junction box.
Decorative Nut
Ground Screw
Wire Path
Bracket
Mounting
Screws
Note: We recommend having an assistant help hold the
lantern assembly during the wiring process.
208949-02
Mounting Screw
Mounting
Plate
SENS
MIN
MAX
Junction
Box
Mounting Plate
This fixture comes with a universal mounting bracket. It is
pre-assembled on the fixture to fit the majority of junction
box applications.
If the slots on the mounting plate do not line up with the
junction box screw holes, follow these steps:
1. Remove the fixture mounting screws from the mounting
plate. Note: Do not remove the ground screw.
2. Attach ground wire "pigtail" to ground screw on
mounting plate (See Recommended Grounding Method
for additional information).
3. Flip the mounting plate over.
4. Rotate the mounting plate so the wire path is on the
upper right. Note: The wire path on the mounting plate
must be located as shown below to allow the wires on
the back of the fixture to pass through.
5. Reinstall the fixture mounting screws and attach the
mounting plate to the junction box as shown.
Wire Path
As Shipped
3
Ground Screw
Fixture Screws
Flipped and
Rotated
Wire Path
Publicidad
