Publicidad
Idiomas disponibles
Idiomas disponibles
Variable Speed Control
The variable speed switch trigger
delivers higher speed with increased
trigger pressure and lower speed
with decreased trigger pressure.
To turn the tool ON, depress the switch
trigger. To turn it OFF, release the switch
trigger and allow the anvil to come to a
complete stop
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed
because excess heat will be
produced internally.
Using The LED Light
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed, and will automatically
turn off 20 seconds after the On/Off
switch is released.
The tool and battery are equipped with a
protection system. When the LED Light
is quickly flashing 3 seconds and turn
off, the system will automatically cut off
power to the tool to extend battery life.
The tool will automatically stop during
operation if the tool and/or battery
are placed under one of the following
conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
Trigger Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In this
situation, let the Tool and Battery cool
before pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
will not operate. In this situation, remove
and recharge the Battery.
WARNING:
To turn on the light, press the On/
Off switch and make sure the Forward/
Reverse Rotation Control is on right/left
position.
20V Cordless Brushless Impact Wrench
All manuals and user guides at all-guides.com
See Fig. E
See Fig. F
See Fig. F
TROUBLE SHOOTING
1. I CAN NOT FIT THE BATTERY INTO THE BATTERY
CHARGER. WHY?
The battery can be inserted into the charger only in one
direction. Turn the battery around until it can be inserted
into the slot, the red LED Light should turn on when the
battery is charging.
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not used
a Battery Pack for a prolonged time will reduce the
Battery Pack working time. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such
as large screws into hard wood will use up the Battery
Pack energy faster than lighter working conditions. Do
not re-charge your Battery Pack below 32
above 86
F (30
C) as this will affect performance.
o
o
MAINTENANCE
Remove the battery pack from the machine
before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of
tool and battery is 0
C-45
o
o
The recommended ambient temperature range for the
charging system during charging is 0
F (0
C) and
o
o
C.
C-40
C.
o
o
EN
11
Publicidad
