Silca Easy Scan Plus Manual De Uso página 9

Easy Scan Plus
Note:
This func on responds only with Silca remote controls.
If remote controls by another manufacturer are used, the
Easy Scan Plus display will show:
IDENTIFICATION / COPY OF A ROLLING CODE NORMAL REMOTE CONTROL
The procedure for iden fying and checking the copy of Rolling Code Normal remote controls is the same as
that for fi xed code remote controls.
When the copy has been made the remote control must be linked to the receiver. This opera on can be
performed by A.L.S. (Simplifi ed procedure to ac vate the remote control on the receiver. The list of receivers
compa ble with the procedure can be found on www.silca.biz.) procedure or according to the procedure
chosen by the receiver manufacturer.
The possibility to use one procedure rather than another is indicated at the end of the copy check func on:
When a copy has been made successfully the display will show the following message:
The message "A.L.S. compa ble" indicates that the copied
remote control can be linked to the receiver by means of
the "A.L.S. procedure".
See the instruc ons given for the Silca remote control
indicated by Easy Scan Plus and on the website www.silca.
biz.
The message "OEM compa ble" indicates that the copied
remote control can be linked to the receiver only by means
of the procedure chosen by the receiver manufacturer.
See the documenta on provided by the receiver manufac-
turer or fi er.
IDENTIFICATION / COPY OF A ROLLING CODE SECURE LEARNING REMOTE CONTROL
Take the remote control to be read up to the reading area
(see fi gure 1) and press any bu on on the remote control.
If there are problems with reading, move the remote
control a few cen metres away and repeat the procedure.
The remote control opera ng frequency is indicated.
The user is required to send the source code for the remote
control to be copied; how to send it depends on the remote
control involved. Check with website www.silca.biz to see
which way is indicated for your remote control.
Copyright Silca S.p.A 2016
Copy check
NOT SILCA REMOTE
Verify again?
(ESC) NO
Copy check
SUCCESSFUL copy
Compatible A.L.S.
Rolling Code
(ENT) to continue
Copy check
SUCCESSFUL copy
Compatible OEM.
Rolling Code
(ENT) to conitnue
Identifi cation
Press any key
on original Remote
(ESC) main menu
Identifi cation
Waiting for
SOURCE code
Wait TLC
(ESC) main menu
English
433 MHz
(ENT) YES
433 MHz
433 MHz
433 MHz
9