Assembling The Vacuum Cleaner - OK. OVC 105 Manual De Instrucciones

ASSEMBLING THE VACUUM CLEANER

1 Insert the suction hose into the hose connection and rotate it to the right (bayonet lock). Make sure
that it has clicked into place.
Place the floor nozzle on the lower end and the suction tube handle on the upper end of the
2
telescopic tube.
3 Adjust the telescopic tube to the desired length, by pressing the locking mechanism down and
then pushing the telescopic tube out or squeezing it together.
USE OF THE ACCESSORIES PROVIDED
Floor nozzle
To vacuum hard floors, press the toggle switch down.
4
To vacuum carpeted areas, press the toggle switch again in order to retract the brushes.
5
Dusting nozzle
6 For vacuuming upholstered furniture, mattresses, cushions, curtains, etc.
Crevice nozzle
For vacuuming folds, crevices and corners.
7
OPERATION
Pull out the connection cable to the desired length and insert the power plug into a receptacle.
8
Press the On/Off switch to turn the vacuum cleaner on/off.
9
Tip: If the vacuum can only be guided with difficulty over carpeted areas due to excessively high
suction power, adjust the suction power down by opening the auxiliary air flap on the handle.
10 Switch the vacuum cleaner off after use and unplug it when you have finished working.
11 Wind the power cable around the cable storage device by pressing the automatic cable retraction
switch. While you are doing this keep the cable taut, if possible.
Parking system for pauses in vacuuming
12 You can store the telescopic tube with the combination nozzle on the vacuum cleaner for short
pauses in vacuuming. Insert the combination nozzle with the parking attachments into the parking
system.
Transport and storage
13 To carry your vacuum cleaner grasp it by the handle in the hollow in the dust canister lid. To store
your vacuum cleaner, the suction tube with the floor nozzle can be mounted on the back of the
vacuum cleaner in an upright position.
IM_OVC105_141129_V03_HR.indb 13
13
En
30/11/14 1:07 PM