ASROCK 880G Pro3 Manual Del Usuario página 27

All manuals and user guides at all-guides.com
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATAIII_1: see p.2, No. 17)
(SATAIII_2: see p.2, No. 16)
(SATAIII_3: see p.2, No. 14)
(SATAIII_4: see p.2, No. 15)
(SATA3_5: see p.2, No. 18)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB10_11)
(see p.2 No. 27)
(9-pin USB8_9)
(see p.2 No. 29)
(9-pin USB6_7)
(see p.2 No. 30)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 32)
ASRock
These five Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
SATA3_5
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there are
three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
This header supports an
optional wireless transmitting
and receiving infrared module.
880G Pro3 Motherboard
2 7 2 7 2 7 2 7 2 7