Publicidad
Idiomas disponibles
Idiomas disponibles
90582820 PCC510 18V OScillating Tool manual.qxd:??????-00 Cir Saw book
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
WARNING:
Always wear proper personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise
from this product may contribute to hearing loss.
1. Sanding of lead based paint is NOT RECOMMENDED due to the difficulty of
Precautions To Take When Sanding Paint
controlling the contaminated dust. The greatest danger of lead poisoning is to children
and pregnant women.
2. Since it is difficult to identify whether or not a paint contains lead without a chemical
analysis, we recommend the following precautions when sanding any paint:
1. No children or pregnant women should enter the work area where the paint
PERSONAL SAFETY
sanding is being done until all clean up is completed.
2. A dust mask or respirator should be worn by all persons entering the work area.
The filter should be replaced daily or whenever the wearer has difficulty breathing.
See your local hardware store for the proper N.I.O.S.H. approved dust mask.
3. NO EATING, DRINKING or SMOKING should be done in the work area to prevent
ingesting contaminated paint particles. Workers should wash and clean up
BEFORE eating, drinking or smoking. Articles of food, drink, or smoking should not
be left in the work area where dust would settle on them.
1. Paint should be removed in such a manner as to minimize the amount of dust
ENVIRONMENTAL SAFETY
generated.
2. Areas where paint removal is occurring should be sealed with plastic sheeting of 4
mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint dust outside the
work area.
1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for
CLEANING AND DISPOSAL
the duration of the sanding project. Vacuum filter bags should be changed
frequently.
2. Plastic drop cloths should be gathered up and disposed of along with any dust
chips or other removal debris. They should be placed in sealed refuse receptacles
and disposed of through regular trash pick-up procedures. During clean up,
children and pregnant women should be kept away from the immediate work area.
3. All toys, washable furniture and utensils used by children should be washed
thoroughly before being used again.
• The label on your tool may include the following symbols. The symbols and their
Symbols
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
All manuals and user guides at all-guides.com
A ..................amperes
W..................watts
n o ................no load speed
opm ..............oscillations per minute
5
................alternating current
..................earthing terminal
................safety alert symbol
12/13/11
9:12 AM
Page
Publicidad
