Jata electro SC1013 Instrucciones De Uso página 9

• To ensure a complementary protection it is advisable
to install in the electrical circuit of the bathroom
a residual differential current device (DDR) of
differential current of assigned capacity that does not
exceed 30 mA. Ask your supplier for advice.
• Allow it to cool before storing.
• This appliance is designed for domestic use only.
• The cleaning and maintenance done by users, can not
be done by children without any supervision.
• If the cable were to deteriorate it must be changed by
an Authorised Service Centre.
INSTRUCTIONS OF USE
• The hair dryer has two switches that control the heat and one pusher for the airflow.
• Connect the appliance to the mains.
• Push the on switch (4) to any of its two positions (- ó =) to obtain a greater or lesser airflow.
• Next push the power switch (3) to any of its positions (- = ó ) to obtain different heat levels.
• The combination of both switches will give you a wide range of options as to the airflow and the heat of the air.
• If you wish to use only cold air while it is on, press the cold air switch (2).
• The air concentrator (6) and the diffuser (7) are placed, onto the hair dryer nozzle, with a slight pressure.
IONISATION FUNCTION
• The hair dryer is equipped with ions generator.
• These ions remove the statical electricity of the hair, causes the division of the water particles in micro particles,
helping to a quick and natural absorption, having a extraordinary finish and brightness for the hair.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning disconnect the appliance from the mains.
• You may clean it with a damp cloth and dry carefully afterwards.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of the
appliance.
• It is very important to keep the air intake (1) and outlet grids always clean.
• Clean them frequently of any hairs or dust, which may get stuck to them.
• To clean the inner grid, remove the air intake grid by turning it anticlockwise.
• Once cleaned replace the grid in its original position and turn it slightly clockwise to leave it correctly fixed.
9