Mag-Torch MT450 Manual De Instrucciones página 2

1. Use only with propane gas cylinders.
2. Turn valve control knob fully clockwise to OFF position.
3. Hold cylinder upright, and screw it into the valve until it is fully seated and hand tight.
4. Leak test connection to cylinder before use. Do not check for gas leaks with a match or open flame. Apply soapy water at cylinder
connection. If bubbles appear disconnect cylinder.
5. Make sure the grip does not cover the air holes. If so, slide the grip away to expose the air holes prior to use.
CAUTION: Tipping the gas cylinder more than 60 degrees from its upright position may cause torch to flare. It is recommended to start
working with a disposable hand torch cylinder at room temperature and to keep torch upright as much as possible.
1. Turn valve control knob (1) ¼ to ½ turn counterclockwise to open the valve.
2. Depress the ignition button (2) to light. If the torch does not light right away, depress the ignition button (2) again.
3. Once lit, turn control knob (1) fully counterclockwise. Do not force.
TO USE
1. Inspect torch before each use. Do not use if torch malfunctions or is damaged.
2. Hold torch by the handle (3) at the curved part of the tube.
3. Sweep burner tip (4) back and forth over target area, keeping the flame about 2" above the ground.
4. SHUT OFF TORCH BEFORE SETTING DOWN.
TO SHUT OFF
1. Turn the valve control knob (1) fully clockwise to OFF position.
2. Wait for flame to extinguish.
3. Set torch down on non-combustible surface and let cool. Tip (4) will remain hot for several minutes after torch is shut off.
REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1. Make sure valve control knob (1) is closed by turning fully clockwise until it stops." Do not force.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children. Observe cautions on cylinder
label.
3. Do not expose cylinders to temperatures in excess of 120ºF.
4. Store cylinders in well ventilated areas.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES
LIGHTING AND OPERATION
200 Old Wilson Bridge Road
Columbus, OH 43085
ASSEMBLY
STORAGE
419769 02/20
MagTorch.com