GE AKV05 Manual Del Propietario Y Instrucciones De Instalación página 10

Installation Instructions
4 PREPARE THE WINDOW
Cut the window seal (2 long strips) to the proper
length. Peel off the backing and attach the seal
to the underside of the window sash.
5. INSTALL THE AIR CONDITIONER
IN THE WINDOW
A.
For wooden windows:
Drive 1/ 2 (12.7 mm) locking screws through
the Frame lock and into the sill.
NOTE: To prevent window sill from splitting,
drill 1/8 (3mm) pilot holes before driving
screws. Drive 1/ 2 (12.7mm ) locking screws
through frame holes into window sash.
B.
For Vinyl-Clad windows:
Drive 1/ 2 (12.7 mm) locking screws through
the Frame lock and into the window sash.
NOTE: Before driving the screws, use a drill to
drill 5 holes through the holes in the Frame lock
and frame extensions into the windows sash.
10
Sealing Strip
(with adhesive)
5. INSTALL THE AIR CONDITIONER
IN THE WINDOW (Cont.)
C.
Place the Frame lock between the frame
extensions and the window sill as shown.
For wooden windows
For vinyl-clad windows
6. INSTALL SASH LOCK AND FOAM
TOP WINDOW GASKET
CAUTION
A.
To prevent broken glass
or damage to windows,
on vinyl or other similarly
constructed windows,
attach the sahs lock to
with one Type B screw.
B.
Cut the foam top window
gasket to the window
width.
C.
Stuff the foam between the glass and the
window to prevent
air and insects
from getting into
the room.
NOTE: If the
gasket supplied
does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.
Vinyl
Wood
49-5000436 Rev. 1