Descargar Imprimir esta página

Hotpoint NVLR223 Manual Del Propietário página 7

Ocultar thumbs Ver también para NVLR223:

Publicidad

Idiomas disponibles

Idiomas disponibles

About the dryer features.
All manuals and user guides at all-guides.com
Press Guard Option
(on some models)
Use this option to minimize the wrinkles
in clothes. It provides approximately
15 minutes of no-heat tumbling after
the clothes are dry.
This option can only be used with the
COTTONS and WRINKLE FREE cycles.
Cycle Signal Option
(on some models)
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models, the signal sound
level cannot be adjusted.
If you selected the PRESS GUARD option,
the signal will sound at the end of the
drying time and will sound several times
during the PRESS GUARD cycle. This will
remind you that it is time to remove the
clothes.
Drum Lamp
(on some models)
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and
replace with the same size bulb.
If you are using the SIGNAL knob and you
select the PRESS GUARD option, a signal will
sound at the end of the drying time and
several times during the PRESS GUARD cycle.
This will remind you that it is time to remove
the clothes.
If PRESS GUARD is not on, the dryer will stop
once the timer reaches the PRESS GUARD
mark on the cycle dial.
NOTE:
I Remove garments promptly at the
sound of the signal. Place clothes on
hangers so wrinkles won't set in.
I Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won't set in.
Hotpoint.com
7

Publicidad

loading

Este manual también es adecuado para:

Nbxr333Nwxr483Nbxr333eg