Publicidad
Idiomas disponibles
Idiomas disponibles
3. Press the rapid heat-up button
The display now continuously shows the remaining warming time. The display starts to flash one minute
before the end of the warming process. The warming process stops once the pre-specified warming time has
elapsed. The heat LED and the display go out.
Starting the warming process without prior warming:
1. Press the
button to switch the device on. The current temperature is shown on the display. The default
setting is 37 °C.
2. To enter the temperature, press the
keeping the food/drink warm (between 35 °C and 85 °C). The temperature increases in the steps 37, 38, 40,
45, 50, 60, 70, 80 until the display reaches "85" and then begins again at 35 °C.
3. Now press the
Ending the warming/keeping warm process:
1. Press the
button for 2 seconds.
The display and the heater are switched off.
2. Remove the bottle/jar using the lifter.
3. Unplug the mains cable after each usage, pour all the water out and dry the device with a cloth.
• Shake the bottle or stir the food in the jar.
• Check that it is the correct temperature.
• To prevent the breeding of bacteria, which multiply fastest in the temperature range from around
32°C to 42°C, please use the heated baby food as soon as possible.
• We do not recommend keeping the food warm for any longer, as this can cause important vita-
mins to be lost.
• For hygienic and microbiological reasons, do not reheat food that has already been heated.
• Take care not to overheat food/liquids.
8. Cleaning and maintenance
The service life of the device depends on its careful handling:
• To extend the service life of the device, we recommend that it is not (continuously) operated in the high
temperature range.
• Use boiled or filtered water for warming baby food. This will reduce the build-up of lime scale.
• Unplug the device before cleaning.
• To clean the device, use only a damp cloth. Do not use any scouring agents or other cleaning products.
• Descale the device using vinegar or citric acid. Place the lifter in the device, mix 50 ml of household vinegar
with 100 ml of cold water or a packet of citric acid with 200 ml of cold water and pour this solution into the
device. Leave the solution to work until the lime scale has been removed; do not operate the device during
this time. Pour the liquid away, rinse the device out thoroughly and finally dry it with a cloth.
• Descale the device approx. every four weeks.
again to start the warming process.
button repeatedly until you have reached the desired temperature for
button again to start the keeping warm process.
11
Publicidad
