HERKULES H-FS 800 Manual De Instrucciones página 17

7.2 Making 45° miter cuts (jolly cuts)
(Fig. 6)
•
Position the table as shown in Fig. 6 and lock
in position with the handles (7). Position the
tile with the glazed side on the work surface
and make sure that the diamond wheel does
not touch the glaze on the tile. Correct the
cutting guiding position if necessary.
•
Fig. 6 shows the correct position for your
hands during miter cutting to 45°. The right
hand holds the workpiece in contact with the
diamond wheel while the left hand pushes the
workpiece forward. The rate of advance must
not exceed the cutting capacity of the wheel.
This is to make sure that no material comes
off, as this may cause accidents or injuries.
7.3 On/Off switch (Fig. 1)
•
To switch on, press the „I" on the On/Off
switch (12).
•
To switch off, press the „0" on the On/Off
switch (12).
8. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
9. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
Anl_H_FS_800_SPK7.indb 17 Anl_H_FS_800_SPK7.indb 17
GB
ingress of water into an electric tool increases
the risk of an electric shock.
9.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
10. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
11. Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
12. Transport
If you want to move the equipment to a diff erent
place, disconnect the equipment from the power
supply and set it up in the new position you want
to use it in.
- 17 -
01.02.2017 08:37:49 01.02.2017 08:37:49