BOMANN BZ 6029 CB Manual De Instrucciones página 48

3. Turn the pressure regulator to the " " position.
4. Use the button to open the lid of the appliance.
5. Remove the CO feed valve
2
from the connector on the
fitting. To do this, press the
white release button labeled
"PRESS" that is located on
the fitting.
6. Insert a new 16 g CO cartridge into the holder as
2
described in the chapter "Inserting the Carbon Dioxide
) Cartridge".
(CO
2
Dismantling Beer Dispenser
To clean the beer dispenser and / or to replace the keg,
it is necessary to remove the dispensing unit from the
dispenser.
CAUTION:
Never remove the dispensing unit from the keg while it is
still pressurized.
1. Switch off the appliance.
2. Disconnect the mains plug from the socket.
3. Turn the pressure regulator to the " " position.
4. Use the button to open the lid of the appliance.
5. Remove the CO feed valve from the connector on the
2
fitting. To do this, press the white release button labelled
"PRESS" that is located on the fitting.
6. Place a container underneath the beer tap.
7. Keep the tap handle pressed until the appliance is no
longer pressurized. There must be no more beer or
foam escaping.
8. Remove the beer hose from the beer connection valve
of the dispensing unit. To do this, press the white release
button labelled "PRESS" that is located on the fitting.
9. Now you are able to remove the keg with the dispensing
unit from the tank of the appliance.
NOTE:
This may require some effort due to the keg being
secured by a suction cup located at the bottom of the
appliance.
WARNING:
• Before cleaning, always remove the mains plug and wait until
the appliance has cooled down.
• Do not immerse the appliance in water. Otherwise this might
result in an electric shock or fire.
48
BZ6029CB_IM
10. Detach the dispensing unit from the
keg:
See the adjacent figure. First, re-
move the right holder. Then push the
left holder out of the keg's edge.
11. Remove the dispensing unit from the
keg by evenly pulling it out.
NOTE:
As the beer tap may not be moist during extraction,
removal may take some effort.
12. The dispensing unit can now be cleaned as described
in the chapter "Cleaning" and subsequently installed
on a new keg as described in the chapter "Piercing the
Beer Keg".
NOTE:
If necessary, replace the CO
in the chapter "Replacing the Carbon Dioxide (CO
Cartridge".
Water Change
There is no need to change the water in the tank every time
a beer keg has been emptied. Exchange the water weekly.
1. Remove the collecting tray from the appliance.
2. After disconnecting the appliance from the power supply,
place it near a table edge and make sure the front feet
are still on the table.
3. Place an empty container than can hold about 1 litre of
water under the edge of the table.
4. To open the outlet, pull the drain lever down. The tank
gets emptied.
5. Use a clean cloth to wipe the tank.
6. Release the drain lever.
7. Use clean water to fill the tank up to the MAX mark.
8. Repeat the procedure in order to rinse the tank.
Cleaning
cartridge as described
2
)
2
07.03.19