Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not install the One Connect upside-down or standing upright on one of its sides.
• When connecting the One Invisible Connection, use a Bending Cover to bend the cable. The Bending
Cover prevents the cable of the One Invisible Connection from being bent at a 90 degree angle. Bending
the cable at a 90 degree angle can damage the cable.
• When connecting the One Invisible Connection, pay attention to the shapes and sizes of its connectors so
that they are connected correctly. Failure to do so may cause product malfunction.
• When connecting the One Invisible Connection, be careful not to twist the cable of the One Invisible
Connection. Failure to do so may cause performance degradation of the TV or damage to the cable.
• When arranging the remaining cable, refer to the figure on the previous page for the correct
arrangement.
• Take care not to subject the cable to any of the actions below. The One Invisible Connection contains a
power circuit. You could damage the cable and subject yourself to an electric shock.
• Handle the One Connect carefully. It is heavy.
Bending
CLASS 1 LASER PRODUCT (One Invisible Connection)
• Caution - Invisible laser radiation when open. Do not stare into beam.
– Do not bend the One Invisible Connection cable excessively. Do not cut the cable.
– Do not place heavy objects on the cable.
– Do not disassemble either of the cable connectors.
• Caution - Use of controls, adjustments, or the performance of procedures other than those specified
herein may result in hazardous radiation exposure.
English - 8
Twisting
Pulling
Pressing on
Electric shock
Publicidad
