Elektrotechnik Schabus SHT 217 Instrucciones De Uso página 11

SHT 217
The device connected is deactivated. The alarm is deactivated as soon as
you briefly disconnect Aquastop SHT 216 from the power line and remove
the cloth from the metal contacts.
For your safety, we recommend that you carry out this test cons-
tantly! Appopriate use
The water detector SHT 217 (pump control) is a device for detecting water
level changes and for monitoring sump shafts. When the sensor gets in
contact with water, an audible and/or visual alarm signal is raised and
a pump connected is activated. The follow-up time of the pump can be
adjusted to a value between 0 and 100 seconds using the thumb wheel.
The device may only be used as previously described.
Installation Instruction
The device is not approved for use other than described above. For pump
sumps we recommend the SHT 227 or 228 water detectors.
Sensor installation
The sensor reacts to water contact at the two metal contacts.
The mounting position of the sensor defines when the pump should be
activated by the device SHT 217 (figure 1).
Sensor
sump shaft
SHT 217
pump
(figure 1)
Follow-up time
100 - 0 s
(figure 2)
11