Buffalo DK208 Manual De Instrucciones página 6

UK
Fault
"CLO" on display Unit in protection mode
Error message The lid is open while the machine is
E01 in Digital in heating mode
Display
NOTE: Sealing bar replacement is not covered under warranty
Technical Specifications
Model Voltage
DK208 220-240V~ 50Hz
Electrical Wiring
This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply
with regulatory standards and specifications set by international,
independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
6
DK208_ML_A5_v1_20210630.indb 6 DK208_ML_A5_v1_20210630.indb 6
Probable Cause
Vacuum Pressure
Power Current
630W 2.7A
change specifications without notice.
Solution
Open the lid, then the unit will return to normal
operation
Close the lid. If the error code persists, there
may be something wrong with the micro
switch, thus Call BUFFALO agent or qualified
technician
Dimensions
(approx.) h x w x d mm
-992mbar 366 x 359 x 425
Weight
(kg)
22.3
2021/6/30 13:09 2021/6/30 13:09