Used Oil Aspirator; Ultrasonic Wash Basin - ELLECI Max Serie Manual De Uso Y Mantenimiento

Manual interventions
14. Used Oils aspirator (Optional)
1) Turning on/Turning off = push the button indicated in the figure
2) Once turned on, the oil aspiration pump remains on for 2 min max. It is possible to deactivate it at any time.
3) If the tank replenishment sensor is activated, the pump turns itself off, a beeping alarm is emitted and the button
flashes off/RED (1 sec./1 sec.).
If you try to turn on the pump again, the beeping alarm will again be emitted
4) The leftover oil must be disposed of through local facilities for the proper disposal of processed-oils.
15. Ultrasonic wash basin (Optional)
If necessary, it is possible to manually perform repairs on some devices, those being:
• SIR (compact drainage system) both the right and left, for allowing water flow from the basin in ab-
sence of power or in case of control panel failure.
It is possible to clean the whole S.I.R. drainage system unscrewing and opening two frontal caps.
Picture 1
not possible to install on Max 900
ATTENTION!
1) Turning on/Turning off = push the button indicated in the figure
2) Once turned on, the Ultrasonic wash basin remains on for 10 min maximum.
3) You can deactivate the device at any time
- THE USED OILS ASPIRATION PUMP SHOULD
NOT BE USED WITHOUT OIL
- DO NOT ASPIRATE HOT OIL
- ASPIRATE ONLY AMBIENT TEMPERATURE OIL
1
EN
33