Cequent CQT63144 Manual página 3

Tools required for assembly: (2) Adjustable wrench
Assembly Instructions
A. Pull bail pin from Mounting Bracket and Arm Assembly.
B. Attach Main Support tube to Mounting Bracket in
orientation shown. Line up the hole near end of main
support tube with the hole in Mounting Bracket and
install one (1) ½" x 3-1/4" lg. hex bolt, two (2) nylon flat
washers, and locknut as shown. Tighten locknut until it
is snug. Main Support tube still should rotate following
tightening. For tilting feature, remove this bail pin and
tilt carrier. DO NOT tilt with bikes loaded.
C. Re-install bail pin thru Mounting Bracket and Main
Support tube so bike carrier is in the upright position.
D. Attach Arm Assembly to Main Support tube as shown.
Line up the holes and install the other hex bolt in the
bottom hole. Secure and tighten the locknut. Re-install
bail pin thru Arm Assembly and Main Support tube.
E. To fold arms down, remove bail pin and rotate arm
assembly down, lining up the holes. Insert bail pin. DO
NOT drive with out bail bin inserted.
Vehicle Mounting Instructions
A. 1-1/4" Receiver hitch use anti-rattle pin and clip as
shown. Tighten with adjustable wrenches. Insert pin
from drivers side only.
B. 2" Receiver hitch use 2" Adapter, anti-rattle pin and clip
as shown. Tighten with ¾" wrench or socket (not
provided). Insert pin from drivers side only.
Bicycle Loading Instructions
A. Bicycles should be loaded with heavier bicycles closest
to vehicle.
B. Load first bike so that the gears and de-railer are facing
away from the vehicle. Load so that the top tube of the
bicycle rests on the rack cradles.
C. Route a cradle strap over top tube of bicycle then loop
strap through heavy plastic loop. To secure strap, place
it back upon itself and pressing hook and loop together.
Check to ensure bicycle is secure and unable to jump
out of cradle.
D. Load additional bicycles, alternating the direction of
each.
All manuals and user guides at all-guides.com
Instructions