Samsung RF28HM Serie Manual Del Usuario página 16

required. If the refrigerator is installed in an area
with low water pressure (below 20 psi), you can
install a booster pump to compensate for the low
pressure. After you have connected the water
line, make sure the water storage tank inside the
refrigerator is properly filled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper
tubing and a ¼" compression nut.
• Use the new hose-sets supplied with the
appliance only. Do not re-use an old hose set.
Connecting to the water supply line
1. First, shut off the main water supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Shut off valve
3. Connect the water line installation kit to the
shut off valve.
Cold water line
Pipe clamp
Shut off valve
DA68-02952A-11.indb 16
Pipe clamp
Water line installation kit
English - 16
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
• ¼" copper tubing • ¼" plastic tubing
• ¼" compression nut
(1pc) • ¼" compression nut
• Ferrule (2pc)
Refrigerator
Compression
Nut (1/4")
(Assembled)
Ferrule
(Not supplied)
Copper tubing
or
(Not supplied)
Household water supply line
1. Connect the household water line to the
assembled compression fitting.
If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and ferrule
(not supplied) on the copper tubing (not supplied)
as shown.
If you are using plastic tubing ( B ) , insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
CAUTION
Do not use without the molded end (Bulb) of the
plastic tubing ( B ).
Use Plastic Tubing
→ Molded end(Bulb)
(1pc)
Plastic Tubing
(Assembled)
Compression
Fitting
(Assembled)
Molded
end(Bulb)
Compression
nut (B) (1/4")
(Not supplied)
Plastic tubing (B)
(Not supplied)
2018. 7. 9. 5:18