Uline H-9235 Manual De Instrucciones página 5

15. Raise other side of tent and attach remaining legs.
(See Figure 21)
Figure 21
16. Fasten the rest of the alligator straps around eave
poles (EV) by tugging on the excess strap to keep
the material taut and pulling the straps firmly. Slide
excess strap through the metal slide on the alligator
clip. (See Figure 22)
Pull to tighten.
CAUTION! Yanking on straps will cause undue
wear and tear as well as wrinkling of tent top
fabric.
IF USING STAKES (H-9235)
1. Place stakes 5' out from each leg. Drive stakes into
the ground until 6" or less of the stake shows.
(See Figure 23)
Figure 23
PAGE 5 OF 24
ASSEMBLY CONTINUED
2. Attach ratchet straps to the stakes loosely.
(See Figure 24)
a. Attach ratchet buckle with loop strap to stakes
b. Pull slipknot tight over stake.
c. Take loop strap attached to tent and pull it
Figure 22
3. Tighten ratchet straps by holding strap and pulling
all slack through ratchet reel. Pull all slack through
ratchet reel, holding strap with one hand and
cranking ratchet handle with the other.
4. Roll excess ratchet straps
and secure into the ratchet
buckle. (See Figure 25)
by turning the 6" loop at the end of the ratchet
inside out and pulling strap through the loop.
through reel bars slot of ratchet.
NOTE: Keep ratchet buckle handle facing up
at all times.
Figure 24
b
a c
Figure 25
Completed Assembly
with Stakes
0721 IH-9235