GRE RBR75 Manual De Instrucciones página 4

EN
POWER ON
Pipe air out
1. Turn the switch on. The indicator light will be
displayed. Loosen the rope on the floater, put
the robot horizontally into the pool and wait for
it to sink to the pool bottom. It takes around 20-
30 seconds for the air to be piped out.
3. When the robot has no power, it will automatically
stop at the edge of the pool (it may also get
stuck in the middle of the pool due to obstacles).
GARBAGE DISPOSAL
1.
2.
3.
TOP
2. Adjust the length of the rope to ensure that it is
at the same height as the water level, and the
extra length of the rope is tied back or cut off.
Note:
1. It is recommended that the filtration system be
turned off as the water circulation in the pool
may affect the robot's motion mode.
2. Any obstacle in the swimming pool such as
a ladder will affect the robot's crawling and
cleaning track.
3. If you are using a brine tank, make sure that all
the salt is dissolved before putting the robot into
the water.
4.
Open this lid to carry
the robot by hand
and to take it out of
the water easily.