Coleman 40 WATT Manual Del Usario página 2

Congratulations on your Coleman® solar product purchase. This product is designed to the highest technical
specifications and standards. It will supply years of maintenance free use. Please read these instructions
thoroughly prior to installation, then store in a safe place for future reference. If at any time you are unclear about
this product, or require further assistance please do not hesitate to contact our trained professionals operating the
customer support line 1-888-478-6435 or email to info@sunforceproducts.com
What's included: Wire connected to solar panel 6.7 ft. (2.04 m), extension wire 8 ft. (2.4 m), Battery Clamps,
Voltage tester with Quick Connect, 7 Amp Solar Charge Controller with Quick Connect Technology
Power Rating: Maximum rating 40 Watts (under ideal conditions)
Current: 2.3 A@ 17.1V
FEATURES:
• High efficiency crystalline solar cells
Quickly connects and disconnects to the battery
•
Overcharge and Discharge protected
•
Weatherproof design
•
Included foldable stand
•
Conveniently comes with extension cable
•
Maintenance free, lightweight compact design
•
OPERATING INSTRUCTIONS
For optimal power, ensure the panel is directly facing the sunlight.
WARNING:
Follow the below instructions carefully to not cause any bodily harm
•
Correct polarity must be observed for product to function properly and safely
•
Risk of fire, electric shock, and injury to persons if operating instructions are not followed
•
Any misuse or tampering of the product and/or any included accessories will void warranty and may cause
•
bodily harm
Follow all safety instructions provided by the battery manufacturer when handling 12V batteries. Always wear
•
safety glasses. Keep sparks, flames and cigarettes away from batteries at all times.
SOLAR PANEL STAND:
On the rear of the panel, simply pull out integrated stand. Extend stand to maximum for securing panel.
For additional stability, add weights to bottom of stand (this step is optional).
CONNECTION SETUP: follow in the following order
1. Solar panel connects to the Quick-Connect extension cord
2. Quick Connect extension connects to the Solar Charge Controller at the 'SOLAR' input
3. The Solar Charge Controller connects via the 'BATTERY' output to your 12v battery (not included), use the
included 'alligator clamps' for this connection. (Red- to the positive terminal, Black to the negative terminal)
(See illustration on next page)
Typical Connection Setup

Solar Panel

Extension wire Charge
Controller
 
Battery Clamps 12V Battery (not
included)