Operation - Ryobi P746 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove the battery pack from the product and
disconnect from the power supply when you are assem-
bling parts, cleaning, or when not in use. Removing bat-
tery pack or unplugging extension cord will prevent acci-
dental starting that could cause serious personal injury.
NOTICE:
Always refer to the manual for any device recommended
for use as an attachment or accessory. Proper use of any
device, when attached to the radio, is the sole respon-
sibility of the operator. Improper use may damage the
device or the product.
WARNING:
This radio is capable of producing sound levels that can
be dangerous to long-term hearing. Listening to music
at high volume for any period of time can cause noise-
induced hearing loss. The higher the volume, the less time
required before your hearing could be affected.
APPLICATIONS
You may use this product for the following purposes:
 Listening to FM/AM radio, MP3 players, CD players, and
other audio devices; charging USB-capable devices.
INSTALLING/REPLACING CLOCK/MEMORY
AAA BATTERIES
See Figure 1, page 11.
It is advisable to write down saved channels before replacing
the AAA batteries.
There is a 15-second time frame for replacing the AAA bat-
teries. If the batteries are not replaced within 15 seconds,
the stereo will lose all settings previously stored in memory,
and they will require reprogramming.
Always use new alkaline batteries for replacement.
 Loosen the screw in the battery door. Remove door and
set aside.
 Install two new AAA batteries according to polarity indica-
tors inside the battery compartment.

OPERATION

INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 11.
To install battery pack:
 Place the battery pack in the stereo, aligning the rib on
the battery pack with the groove in the stereo's battery
port.
 Make sure the latches on the battery pack snap into
place and the battery pack is secured to the stereo before
beginning operation.
NOTE: Leaving the battery pack connected for long periods
of time may drain the battery pack. Always disconnect bat-
tery packs after use.
To remove battery pack:
 Depress the latches on both sides to release the battery
pack from the stereo.
NOTE: Always remove battery pack from stereo when
not in use.
NOTE: The battery pack should be recharged after approxi-
mately five hours of use to reduce the possibility of damage.
Repeated deep discharge of the battery may decrease stor-
age capacity and battery life.
INSTALLING/REMOVING POWER CORD
See Figure 3, page 12.
 Push the ON/OFF button to turn the stereo OFF.
 Depress the latches on both sides to release the battery
pack from the stereo.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
LCD DISPLAY
See Figure 4, page 12.
NOTE: The illustrations of the LCD display shown in this
manual are only examples of the frequencies you may see
on your stereo and are not the exact frequencies that you
may choose to listen to.
When the stereo is not connected to a power supply, the
LCD display will remain off. If the stereo is connected to a
power supply and in the ON position, LEDs will light the
display. You can view the time, frequency, and settings in
use on the LCD display.
NOTE: Always disconnect battery packs after use to prevent
draining the battery pack.
6 - English