PulsNell PL Serie Manual De Instrucciones página 5

Switch Modes
Short Press
Angle Measuring Horizontal Measuring
Golf Mode Vertical Measuring
1. Short press the " " button to turn on the device.
2. After starting up, short press the "
measurement; Press and hold the "
scanning measurement.
3. After starting up, short press the "
modes; Press and hold the "
or Yard.
4. Under golf mode, short press the "
when the icon " " stops flicking and the machine body vibrates,
the angle and slope compensation distance will display above the
LCD in turn, and the straight line distance display below the LCD.
Switch Units
Long Press
Yard
Meter
" button for single
" button for continuous
" button to switch measuring
" button to switch the unit: Meter
" button to start measuring,
-5-
Kindly Notice:
1. The continuous scanning function does not work in golf mode.
2. The reading at the bottom of the LCD is always the straight line
distance.
3. When the distance is beyond its measuring range, will have no
distance measurement reading, but show "----".
Troubleshooting
Dark spots exist in the optical observation system. The LCD display
screen is produced in an advanced dust-free plant. When used, the
LCD display area will be presented with several times the display
effect, which will neither influence measuring ability nor be
completely eliminated.
Please exclude the below possibilities if any
measurement fault:
1) Please confirm if the battery's power is exhausted or not.
2) Please confirm the battery's positive and negative poles are
correctly installed.
3) Confirm that the product is started up, and the LCD displays.
4) Confirm if other objects beyond the target block the emission and
reception eyepiece.
5) Confirm that is measured target is > 5 meters and in its maximum
measuring range.
6) For precise or long-distance measuring, please use a tripod
based on the actual situation.
7) To measure the object's distance, keep the measured target
vertical with the laser beam as far as possible.
-6-