Husqvarna 97045900100 Manual Del Operador página 14

CONTROLS
To Adjust The Seat
A
1. Lift seat up and remove seat adjustment knob
(A).
2. Loosen seat adjustment knob (B).
IMPORTANT INFORMATION
seat adjustment knob (B).
3. Move seat to necessary position, line up the
hole in the seat pan for seat adjustment knob
(A) with the hole in the seat.
4. Install and tighten seat adjustment knob (A).
5. Tighten seat adjustment knob (B).
Bypass Linkages
Transaxle bypass linkages must be engaged
when pushing or pulling the mower. The release
levers are located on each side of the rear of the
unit below the rear engine guard. See Moving
Machine By Hand in the Operation section.
WARNING!
located close to the muffler. To prevent burns,
the engine should be shut off and allowed
to cool before the bypass linkage levers are
handled.
14
B
Do not remove
Bypass linkages are
Fuel Shut Off Valve
The fuel shut off valve is located at the right rear
of the seat. The valve is off when the handle tab is
turned perpendicular to the fuel line.
Tracking
If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 15 psi (1 bar).
Tracking adjustments are made using the tracking
bolts. The tracking bolts limit the motion control
levers when in the full-forward position.
1. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
2. Using a 1/2" wrench, back the tracking bolts
out until flush with nut.
3. Test operate unit by driving it at full throttle
and the full forward position on both motion
control levers. Gradually turn in the tracking
bolt on the right hand side until the unit
noticeably starts drifting right.
4. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the left tracking bolt until unit
tracks straight.