Publicidad
Idiomas disponibles
Idiomas disponibles
English
3 white LEDs flash for 5 seconds, then device powers off
1 white LED blinks for 3 seconds, then turns back to solid
red or blue.
1 white flashing LED
First white LED solid, second white LED flashing
2 solid white LEDs, third white LED flashing
All LEDs off
nOTE: While charging, the charger may get warm, this is perfectly normal and safe. It is
safe to leave the product connected to the charger indefinitely. The charger automatically
reduces power consumption when charging is complete.
nOTE: The device can not be used while charging or even plugged in while fully charged
nOTE: If 3‑position power slider is in the warm or cool mode, the device won't automatically
turn on after charger is removed. The slider has to be reset to the center/off position, then
moved to warm or cool mode position for functionality to start again
nOTE: When charging cable is unplugged, all LEDs shut off.
•
Adaptor rating: 5V/2A
Electronic Protection System
Lithium Ion products are designed with an Electronic Protection System that will protect the
battery against overloading, overheating or deep discharge. The product will automatically
turn off and the battery will need to be recharged.
ASSEMBLY AND ADJUSTMENTS
Inserting into Lanyard (Fig. C, D)
WARNING: Ensure the air intake and air vent are not obstructed.
1. Insert the bottom of the ComfortPak into the lanyard cooling/heating plate opening
until it contacts the bottom of the lanyard as shown in Fig. C.
2. Wrap the top of the lanyard over the top of the ComfortPak so it sits fully in the lanyard.
3. Ensure each part sits perfectly in its corresponding place within the lanyard as shown in
Fig. C and D.
-
3‑position power slider
-
Increase strength button
-
Decrease strength button
Cooling/heating plate
-
8
1
2
3
4
0% charged
< 10% charged
0 ‑ 33% charged
33 ‑ 66% charged
66 ‑ 99% charged
100% charged
-
Indicator LEDs
-
Air intake
6
-
Air vent
7
Charging port
-
5
9
11
Publicidad
