Uline H-7236 Instrucciones De Ensamble

π H-7236
CAFE TABLE – 36" ROUND
TOOL NEEDED
5/32" Allen Wrench
Center Brace x 1
NOTE: It is recommended to assemble unit on
clean, flat, solid surface. Use a drop cloth to avoid
scratching the finish.
NOTE: Do not fully tighten bolts and nuts until table
is completely assembled.
1. Locate all parts before assembly begins.
2. Invert top and set on a protective surface. Loosely secure
legs to table frame using two 5/8" socket head cap
screws, two screw caps and two flat washers per leg (will
tighten in step 5). (See Inset B)
3. Loosely attach center brace to legs using one 5/8" socket
head cap screw, one 1⁄" socket head cap screw, two
screw caps and two flat washers per leg (will tighten in
step 5). (See Inset A)
4. After all parts have been secured, carefully rotate table to
its upright position.
5. Adjust and level table. Tighten all hardware.
• Regular inspection and maintenance of all parts and
fasteners is necessary.
• Tighten all bolts and nuts. Inspect tops, seats, legs, braces
and fasteners periodically for wear or vandalism.
PAGE 1 OF 3
1-800-295-5510
uline.com
Table Top x 1
ASSEMBLY
MAINTENANCE
PARTS
Screw Cap x 16
1⁄" Socket Head
Leg x 4
Cap Screw x 4
INSET A
Figure 1
5/8" Socket
Head Cap
Screw
Screw Cap
Flat Washer
1⁄" Socket
Head Cap
Screw
Center
Brace
• Replace broken or worn parts immediately or take
equipment out of service until repairs are made.
• Contact Uline Customer Service at 1-800-295-5510 for
replacement parts.
• Keep these instructions for future reference.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Flat
Washer x 16
5/8" Socket Head
Cap Screw x 12
INSET B
Screw Cap
5/8" Socket Head
Cap Screw
Flat Washer
Table Frame
Table Top
0623 IH-7235