BWT Aquabot UR200 Funcionamiento página 5

Maintenance and Storage
Cleaning the filters
The two filters must be cleaned after each cleaning cycle. (1) Release the
filter and pull it out of the cleaner unit. (2) Open the filter case. (3) Spray
water on the outer sides of the filter and then spray water towards the
inner side of the filter to clean all the dirt and debris. (4) Reinsert the filter
back into its location until a click is heard to secure the filter in place.
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in
use: (1) Disconnect the power cord from the wall outlet. (2) Disconnect
the floating cable from the power supply. (3) Spread out the floating
cable, and roll it. (4) Wash the cleaner unit interior space with fresh
water and let it dry. (5) Roll the floating cable and place it on the cleaner
unit. Caution: Do not roll the floating cable on the handle of the cleaner
unit. (6) Store the robotic cleaner components in a dry, closed location.
(7) Verify that the supply is not exposed to water.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the
propeller of the water outlet: (1) Remove the filters (2) Remove the
screws that holds the water outlet cover. (3) Remove the water outlet
cover (4) Clean any hairs, dirt, or debris. (5) Return the cover and fasten
it with the screws (6) Reinsert the filters.
5
UR200 / UR300 / UR400 ROBOTIC POOL CLEANERS