Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting Bits
Your tool is equipped with a bit holder
1. Simply push a bit 10 into the bit
holder 1 as far as it will go (Fig. 1).
Direction of Rotation
use the direction of rotation switch
while the power tool is in operation.
slide the direction of rotation switch to
middle (locked) position when storing
or transporting the tool.
Clockwise rotation: To drive screws in,
slide the direction of rotation switch 2
down or forward to position A (Fig. 2).
Counterclockwise rotation: To loosen
or unscrew screws, slide the direction
of rotation switch 2 up or backwards to
position B (Fig. 2).
Locking the shaft in place: To lock the
shaft (bit holder 1) in place, slide the
direction of rotation switch 2 into the
middle position C (Fig. 3). This enables
screws to be screwed in manually, e.g.
when the battery is depleted. Note: the
On/Off button 6 is disabled when the
direction of rotation switch is in the
middle position.
Setting the Torque
The Electric Screwdriver torque can be
set in one of six positions using the
torque selector 4. There are five setting
to limit the torque and one setting for
maximum power.
automatically stop as soon as the set
torque is reached.
Use the lowest torque setting indicated
by the small screw icon for soft
materials and small screws. Rotate the
torque selector to increase the amount
of torque for larger screws and harder
materials. For maximum power, adjust
the torque selector to "Max" position.
Starting and Stopping the
Tool
There are two ways to start the tool:
a.
To start the power tool, put pressure
Operating Instructions
To prevent damage
to the tool, do not
To prevent accidental
activation of the tool,
The tool will
Fig. 2
A
Fig. 3
on the bit holder 1 and maintain this
pressure to continue using the power
tool. To switch the tool off, stop
putting pressure on the bit holder 1.
b.
To start the power tool, press and
hold the On/Off button 6. Release the
On/Off button to stop the tool.
Smart Stop
Your electric screwdriver comes with
Smart Stop feature. If the electric
screwdriver is misaligned with the
screw, it will automatically stop to
prevent damage to the screw head (Fig.
-11-
B
2
6
4
1
C
2
6
4
1
Publicidad
