Kicker ZXDSP1 Manual Del Propietário página 8

High, Mid and Low wiring
In this confi guration, the Front Row is used to drive your tweeters, midrange/midbass drivers and subwoofers
separately; each with their own amplifi er, crossover points and time alignment. Use this confi guration with a set of
components that require active crossovers and independent time alignment.
Set the FRONT FREQUENCY switch to a factor of X10 and adjust the HI-PASS crossover for tweeter use
(Recommended starting point of 3KHz).
Confi gure the REAR/SURROUND channel for mids by using the crossovers as a band-pass fi lter. Set the LO-
PASS switch to ON and the FREQUENCY switch to a factor of X10, then adjust both the HI-PASS and LO-PASS
crossovers accordingly (Recommended starting points of 80Hz and 3KHz, respectively).
Adjust the SUBWOOFER channel's
LO-PASS crossver to 80Hz.
This confi guration allows you to time
align your left mid/mid-bass speaker
and left tweeter separately for
an optimal driver's-side listening
experience. You will not be able to
use the Surround Sound function
and it should be turned OFF.
Once the crossovers and OUTPUT
LEVEL controls on your Front Row
are confi gured, use the remote
control to fi ne-tune the sound.
sub channel
8
2012 FrontRow (ZXDSP) Rev G.indd 8 2012 FrontRow (ZXDSP) Rev G.indd 8
sub
subwoofer amplifi er
full
mid-channel
2 or 4-channel
full-range amplifi er
factory source unit /
factory amplifi er
full-range signal
Front Row
high-channel
(tweeters)
2 or 4-channel
full-range amplifi er
4/30/2012 1:55:50 PM 4/30/2012 1:55:50 PM