Publicidad
Prepare the wall mount
1
Slide the wall-mount cover up to detach it from
the bracket.
2
Mark the wall where you want to insert the
provided anchors and screws, which must
be 2.44 in. (62 mm) apart, and drill a 10mm
(25/64") pilot hole for each anchor.
3
Insert the anchors and screws, leaving about
0.25 in. (6 mm) of each screw protruding from
the wall.
When the screws are placed correctly, the holes
at the back of the mounting bracket fit over the
protruding screws, allowing you to slide the
mounting bracket downward until the tops of the
slots are resting on the screws.
2.44 in. (62 mm)
3
Publicidad
