FONESTAR ZSC-1110 Manual De Usuario página 5

ALARM PAGING
The LINE 1 and LINE 2 inputs can be used as audio inputs for emergencies. These inputs are automatically
activated in all inputs when the ALARM IN A/B contacts are closed. The priority level of the different inputs
is as follows: LINE IN 2 -> MIC 1& MIC 2 -> LINE IN 1.
BROADCASTING MUSIC FROM THE ZS-11 MICROPHONES
The microphone ZS-11 has an audio input for broadcasting background music. In order to use this function,
connect an audio source to the LINE IN input (6.3 mm jack connector) of the ZS-11 microphone, then
activate the zone or zones in which you wish the music to be heard by pressing the zone buttons on the
microphone ZS-11 or from the zone system ZSC-1110 by pressing the corresponding zone button (the
MUSIC/PAGING indicator must be lit in red in order to activate this input).
CONNECTION
- With all equipment disconnected from the mains, connect the players, amplifiers and dynamic
microphones of your installation.
NOTE: the zone system can operate with one or more 100 V amplifiers for ambient music and
announcements, with a maximum power of 500 W per zone or 5.000 W for all 10 zones.
- Connect the ZS-11 microphones you need, maximum 16 microphones.
- Up to 30 ZSC-1110 units can be connected for up to 300 zones. If you are connecting more than one
ZSC-1110 devices you must configure the DEVICE ID selector, as explained above, to correctly identify
each zone.
- Once the connections have been made according to your needs, connect the devices to the power
supply and switch them on. After use, do not forget to switch it off and disconnect it from the mains.
- 5 -
EN