BGS technic 6035 Manual página 3

Intermediate Levers Slide Block, for BMW B38 / B48
TOOLS
3 Intermediate Levers Slide Block
Additionally required tool:
Intermediate Lever Spring Tool,
for BMW B38 / B48 (BGS 6036)
INTENDED USE
•
for removing and installing the torsion spring of the valve intermediate lever
•
allows quick, easy and safe handling of these high-force springs
•
suitable for BMW and Mini engines B38 A15 A, B38 B15 A, B38 K15 A, B48 A20 A, B48 A20B,
B48 B20 A, B48 B20B, built in BMW 1series, 2 series, 3 series, 4 series, X1 (2015-), X2 (2018-),
i8 (2014-) and MINI Hatch (2014), Clubman (2015), Countryman (2017)
•
is used in conjunction with Intermediate Lever Spring Tool | for BMW B38 / B48 (BGS 6036)
to be used as OEM 2 359 088
More information regarding this item and a list of suitable engines and models can be found on our
website: www.bgstechnic.com
SAFETY INFORMATIONS
•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Keep children and other unauthorized persons away from the work area.
•
Do not allow children to play with the tool or its packaging.
•
Be careful when working on hot engines because of the risk of burn injuries.
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the
timing again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
•
Do not use locking tools for camshaft and crankshaft as a counter-holder, during loosening or
tightening screws on pulleys, camshafts or crankshafts. This can damage tools and engine
components. Only use tools that are suitable for this purpose.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6035
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed