Publicidad
Idiomas disponibles
Idiomas disponibles
Before starting work, check the integrity of all components.
1. Connect the hose to the machine connector and make sure that there are no leaks. Use
Teflon in the screw connector and tighten with a wrench. This machine is compatible with pumps
with maximum pressure of 700 bars.
2. Remove the stud and put the spreaders in the flange. Line up the holes of the flange
spreaders with the lateral plates and insert the stud through the lateral plates and holes. Insert
the safety studs.
3. Close the external drain valve of the pump.
4. Use the lever of the pump until to get the correct separation of the flange.
GUIDE OF USAGE
7
Publicidad
